Re: Quick question about ODR

I've both used one and and not used one, but never had any problem with
functionality....

You use the network statement to DIRECT which interfaces you are sending
the 0/0 to. Otherwise with just "router odr" you'll blast that out to
all your CDP interfaces/neighbors which may not be what you want.

HTH,

*Scott Morris*, CCIE/x4/ (R&S/ISP-Dial/Security/Service Provider) #4713,

JNCIE-M #153, JNCIS-ER, CISSP, et al.

JNCI-M, JNCI-ER

smorris_at_internetworkexpert.com

Internetwork Expert, Inc.

http://www.InternetworkExpert.com

Toll Free: 877-224-8987

Outside US: 775-826-4344

Knowledge is power.

Power corrupts.

Study hard and be Eeeeviiiil......

Ryan West wrote:
> Hello,
>
> I had my last short session on the ASET labs last night for some final
> warm-ups. And I ran into an issue with ODR. It seems the correct answer was
> to include a network statement on the hub router. The configuration guide
> would leave you to believe that feature doesn't even exist. As far as syntax
> and timers go, it's very RIP like, so I can understand the desire to want to
> include a network statement. However, the spoke router was getting its
> default route via o... Any idea why a network statement would be used?
>
> Thanks
>
> -ryan
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Mon May 11 2009 - 10:39:08 ART