Re: HSRP Ver 1 and Ver 2

There are a few options related to the show standby command ... these might
help some.

The link in the doccd is (watch the ugly word wrap):

http://www.cisco.com/en/US/docs/ios/ipapp/configuration/guide/ipapp_hsrp_ps6350_TSD_Products_Configuration_Guide_Chapter.html

Apart from looking at the options and all ... I have always found the debugs
to be pretty good. Have you tried these?

Version 1 is the default, so perhaps configure version 2 on another router,
and watch the debugs. According to the docs, version 2 will be displayed
if it has been configured.

HTH,

Andrew Lee Lissitz

On Sat, May 30, 2009 at 3:20 PM, Rsharma <cciers09_at_gmail.com> wrote:

> Hello All,
>
>
> Just curious to know about ...how can we verify about current HSRP version
> running on routers.
>
> R1#*show standby*
> Ethernet1 - Group 1
> Local state is *Active, priority 105*, may preempt
> Hellotime 3 sec, holdtime 10 sec
> Next hello sent in 0.338
> * *Virtual IP address is 192.168.21.10 configured
> Active router is local
> Standby router is 192.168.21.2 expires in 8.280
> *Virtual mac address is 0000.0c07.ac01
> >>>>>>>>>>>>> Apart from this output .Is there any other idea to
> confirm abt HSRP Version ????*
> 13 state changes, last state change 00:46:10
> IP redundancy name is "hsrp-Et0-1"(default)
> Priority tracking 1 interface, 1 up:
> Interface Decrement State
> Serial0 10 Up
>
>
> * Rsharma*
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>

-- 
Andrew Lee Lissitz
all.from.nj_at_gmail.com
Blogs and organic groups at http://www.ccie.net