Re: How I can check if my switch port support inline power or

show power inline (interface typ)

On Mon, Jun 29, 2009 at 3:08 PM, Ali El Moussaoui <mousawi.ali_at_gmail.com>wrote:

> Test-Switch#sh int fa1/0/1 cap
> FastEthernet1/0/1
> Model: ME-C3750-24TE
> Type: 10/100BaseTX
> Speed: 10,100,auto
> Duplex: half,full,auto
> Trunk encap. type: 802.1Q,ISL
> Trunk mode: on,off,desirable,nonegotiate
> Channel: yes
> Broadcast suppression: percentage(0-100)
> Flowcontrol: rx-(off,on,desired),tx-(none)
> Fast Start: yes
> QoS scheduling: rx-(not configurable on per port basis),tx-(4q2t)
> CoS rewrite: yes
> ToS rewrite: yes
> UDLD: yes
> *Inline power: no
> * SPAN: source/destination
> PortSecure: yes
> Dot1x: yes
>
> HTH
>
> On Mon, Jun 29, 2009 at 3:01 PM, CCIE <ccie_at_axizo.com> wrote:
>
> > Hi Experts,
> >
> > How I can check if my switch port support inline power or PoE?
> >
> > Regards,
> >
> > Amin
> >
> >
> > Blogs and organic groups at http://www.ccie.net
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Mon Jun 29 2009 - 15:27:06 ART