BFD ques

Group

Hope all of you are doing great !
small query :

As i read from OSPF doc cd

Router> enable

Router# configure terminal

Router(config)# interface fastethernet 3/0

Router(config-if)# ip ospf bfd

Router(config-if)# end

But I do not get the same command on my ospf enable interface .

3825_UP(config-router)#do sh run int g0/0
Building configuration...

Current configuration : 112 bytes
!
interface GigabitEthernet0/0
 ip address 1.1.1.1 255.255.255.0
 duplex auto
 speed auto
 media-type rj45
end

3825_UP(config-router)#int g0/0
3825_UP(config-if)#ip os
3825_UP(config-if)#ip ospf ?
  <1-65535> Process ID
  authentication Enable authentication
  authentication-key Authentication password (key)
  cost Interface cost
  database-filter Filter OSPF LSA during synchronization and flooding
  dead-interval Interval after which a neighbor is declared dead
  demand-circuit OSPF demand circuit
  flood-reduction OSPF Flood Reduction
  hello-interval Time between HELLO packets
  lls Link-local Signaling (LLS) support
  message-digest-key Message digest authentication password (key)
  mtu-ignore Ignores the MTU in DBD packets
  network Network type
  prefix-suppression OSPF prefix suppression
  priority Router priority
  resync-timeout Interval after which adjacency is reset if oob-resync is
                       not started
  retransmit-interval Time between retransmitting lost link state
                       advertisements
  transmit-delay Link state transmit delay

3825_UP(config-if)#ip ospf

My software version is c3825-ipbase-mz.124-24.6.T5

PLease suggest
Gaurav Madan
CCIE

Blogs and organic groups at http://www.ccie.net
Received on Thu Jul 02 2009 - 18:04:40 ART