Re: AT over MPLS

Hi Rich,

My understanding is that, CLI itself is getting rejected. So the debugs and
show outputs may not help here. I think he can try 12.2S based versions.

Thanks,
Srinivas

On Fri, Jul 31, 2009 at 1:48 AM, Rich Collins <nilsi2002_at_gmail.com> wrote:

> You can run this debug on R7 and R8.
>
> R7#debug mpls l2transport ?
> fast-reroute ATOM Fast Reroute
> ipc IPC event
> packet packet debug options
> signaling Signaling protocol
> vc Virtual circuit
>
>
> Then check both with
>
> R8#sh mpls l2transport vc
>
> Local intf Local circuit Dest address VC ID Status
> ------------- -------------------- --------------- ---------- ----------
> Se1/0 PPP 4.4.4.4 100 UP
>
>
> R8#sh mpls l2transport vc de
> Local interface: Se1/0 up, line protocol up, PPP up
> MPLS VC type is IP, interworking type is IP
> Destination address: 4.4.4.4, VC ID: 100, VC status: up
> Output interface: Fa2/0, imposed label stack {16}
> Preferred path: not configured
> Default path: active
> Tunnel label: imp-null, next hop 24.24.24.4
> Create time: 00:08:15, last status change time: 00:03:42
> Signaling protocol: LDP, peer 4.4.4.4:0 up
> MPLS VC labels: local 21, remote 16
> Group ID: local 0, remote 0
> MTU: local 1500, remote 1500
> Remote interface description:
> Sequencing: receive disabled, send disabled
> VC statistics:
> packet totals: receive 24, send 32
> byte totals: receive 2400, send 3904
> packet drops: receive 0, send 0
>
> -Rich
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Fri Jul 31 2009 - 13:14:29 ART