Re: STP Timer values on the secondary bridge

I think if this is Rapid SPT we need to modify it on all Switches....Right
or Wrong ??

----- Original Message -----
From: "Anantha Subramanian Natarajan" <anantha.natarajan_at_gravitant.com>
To: "Cisco certification" <ccielab_at_groupstudy.com>
Sent: Saturday, September 05, 2009 4:07 AM
Subject: STP Timer values on the secondary bridge

> Hi All,
>
> I was going through spanning tree protocol and here by referencing the
> below paragraph read
>
> "You can only modify the timer values from the root bridge.Modifying the
> values on other bridges has no effect.However,don't forget to update any
> "backup" root bridges "
>
> My question is ,if for example in the real lab they give a task to
> configure
> SW1 has primary root for vlan x and SW2 has secondary root for Vlan x and
> then in another task,if they ask to change the forward-delay timer value
> to
> y seconds for Vlan x,do we have to configure this on both root primary and
> secondary switch.I heard many times that we don't neeed to worry about
> redundancy unless specifically asked in the lab.But just want to make
> sure,if they ask the above task,can we just configure the timer value on
> the
> root primary and not on the secondary.
>
> Kindly clarify the same.Thanks for the help
>
> Regards
> Anantha Subramanian Natarajan
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>

--------------------------------------------------------------------------------

No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.409 / Virus Database: 270.13.76/2345 - Release Date: 09/04/09
05:51:00

Blogs and organic groups at http://www.ccie.net
Received on Sat Sep 05 2009 - 14:52:41 ART