Re: Multilink PPP

Have a look at this link, I wrote this a while back and pretty much answers your question.

http://www.fnode.com/2009/09/how-to-configure-ppp-multilink/

------Original Message------
From: ccie_ka_at_gmx.de
Sender: nobody_at_groupstudy.com
To: ccielab_at_groupstudy.com
ReplyTo: ccie_ka_at_gmx.de
Subject: Multilink PPP
Sent: 18 Feb 2010 08:14

Hi GS,

currently I configure multilink ppp over serial interface.
Now I'm confused about a behavior ..

Assume first I configure the serial link s0/0 with encaps ppp. This interface has also an ip address assigned.
Then I configure a routing protocol over this line...all works fine.
After that I should configure ppp multink over this interfaces.

1. What is the correct order of configuring this ? Should I at first configure the multilink interface and than attach to the serial IF ?
Or should I first configure the association on the serial interface an then create the multilink interface ?

2. What about the IP addresses ? I found out after configuring the multilink interface the routing neighors are between the multilink interface although the same ip address is on both interfaces ( serial and multilink)
Therefore should I remove the ip address from the serial link ?? Is the multilink interface the part for all layer 3 configuratins ?

Dennis

-- 
Sicherer, schneller und einfacher. Die aktuellen Internet-Browser -
jetzt kostenlos herunterladen! http://portal.gmx.net/de/go/chbrowser
Blogs and organic groups at http://www.ccie.net