Just one more point to make...hopefully you are not working with old IOS codes (i.e. prior 12.1) because what they do basically is that they leave the default-class "unprotected" (against classified packets and if it's unconfigured) so it's very possible that you see experience packet loss in your network especially for your "unclassified" flows. In almost all those old codes, you however will still have WFQ enabled for that class.
Does it make sense?
--------------------------
Kambiz Agahian
CCIE (R&S)
CCSI, WAASSE, RSSSE
Technical Instructor
CCBOOTCAMP - Cisco Learning Solutions Partner (CLSP)
Email: kagahian_at_ccbootcamp.com
Toll Free: 877-654-2243
International: +1-702-968-5100
Skype: skype:ccbootcamp?call
FAX: +1-702-446-8012
YES! We take Cisco Learning Credits!
Training And Remote Racks: http://www.ccbootcamp.com
OEQ Voice Waiver: http://www.ccbootcamp.com/noeqvoice.html
OEQ R&S Waiver: http://www.ccbootcamp.com/noeqrs.html
OEQ Commercial: http://www.ccbootcamp.com/noeq.mpg
-----Original Message-----
From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of Bit Gossip
Sent: Thursday, April 29, 2010 1:56 PM
To: ccielab
Subject: MQC class-default
Experts,
the below quote from DocCD MQC class-default:
"If no default class is configured, then by default the traffic that
does not match any of the configured classes is flow classified and
given best-effort treatment."
1) what does it mean: it is flow classified?
Maybe that within the class-default itself WFQ is used to fair treat all
flows in the class
2) what does it mean best-effort in this context? that is served only
after all CBFQ are service?
Thanks,
Bit
Blogs and organic groups at http://www.ccie.net
Received on Thu Apr 29 2010 - 14:29:12 ART
This archive was generated by hypermail 2.2.0 : Sat May 01 2010 - 09:49:57 ART