Re: How to configure redundancy on access port?

How about running VRRP/HSRP on the two 6506 switches on those specific Vlans ?

Point the PC to use the virtual IP as the gateway. Problem is that the PC has 1 physical connection to 1 access switch. If that switch falls over then you need to swap cables to the other switch. Are the access switches running L2 only or Layer 3 ?

My above statement assumes the access switches are L2 only and the Vlan interfaces are running on the 6506's

CCIE # 23962 (SP)

Sent from my iPhone 4

On 22 Mar 2011, at 12:52 PM, Firoz P <firoz.pp_at_Sacsgrp.com> wrote:

> I have two core switches 6506 with redundant connection to each other
> Each cabinet has 2 access switches and access switches are also in redundancy
> to core switches.
> I have 1 UTP cable Connection to PC from each access switches from the same
> cabinet
> How can I make loop free on this network for user side.
>
>
> Firoz
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Tue Mar 22 2011 - 13:55:01 ART