Re: EIGRP authentication on a Mulitpoint subinterface

 virtual-templates is right on!

R3#sh ip eigrp neighbors
IP-EIGRP neighbors for process 1
H Address Interface Hold Uptime SRTT RTO Q Seq
                                            (sec) (ms) Cnt Num
0 31.31.31.2 Vi3 11 00:08:36 139 834 0 18
1 31.31.31.1 Vi2 12 00:11:22 1230 5000 0 8

R3#sh ip eigrp interface detail | i V|Authentication
Vt1 0 0/0 0 0/1 0 0
  Authentication mode is md5, key-chain is "CISCO"
Vi2 1 0/0 1230 0/1 7441 0
  Authentication mode is md5, key-chain is "CISCO"
Vt2 0 0/0 0 0/1 0 0
  Authentication mode is not set
Vi3 1 0/0 139 0/1 545 0
  Authentication mode is not set
  Authentication mode is not set

--
Garry L. Baker
"With sufficient thrust, pigs fly just fine..." - RFC 1925
On Tue, Sep 20, 2011 at 6:57 PM, Jay McMickle <jay.mcmickle_at_yahoo.com> wrote:
> I believe you can do this with virtual-templates and with sub-interfaces on R2. I would need to look. Good question.
>
> Regards,
> Jay McMickle- CCNP,CCSP,CCDP
> Sent from my iPhone
> http://mycciepursuit.wordpress.com
>
>
> On Sep 20, 2011, at 9:11 AM, "amin" <amin_at_axizo.com> wrote:
>
>> Hi experts,
>>
>> Can I configure my multipoint sub-interface that goes to R1 and R2 to
>> authenticate EIGRP relation with R1 and no authenticate EIGRP with R2.
>>
>> Regards,
>>
>> Amin
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net