RE: OT:Tengig Ports not connected error

Hi Sandro

For your reply i did follow the procedure.But once i connect the Fiber its
giving me an error "Failure to detect" and interface remain down

Kindly note i need to connect 10 G on both side

Thanks

Date: Sun, 22 Jan 2012 20:50:31 -0200
Subject: Re: OT:Tengig Ports not connected error
From: sandro.unix_at_gmail.com
To: nmaxpierson_at_gmail.com
CC: faizankhurshid921_at_hotmail.com; ccielab_at_groupstudy.com

Faizan,

I have the same opinion. Please check the link sent by Max.
"To configure the modes of operation for each X2 port group in which you want
to deploy Gigabit, enter the hw-module module <m> port-group <p> select
gigabitethernet command. "

Rgs,
2012/1/22 N. Max Pierson <nmaxpierson_at_gmail.com>

Hi Faizan,

Have you configured the module to support 1g instead of 10g (10g is the

default)???

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/46sg/configura
tion/guide/sw_int.html#wp1077316

HTH's,

max

On Sun, Jan 22, 2012 at 6:14 AM, faizan khurshid <

faizankhurshid921_at_hotmail.com> wrote:

> Hi Experts

>

> I have one Core WS-C4510R-E with WS-X45-SUP6-E .Im geeting following

> error

> once i reboot my Switch .A device can detect 10G ports but status remain

> down

> even using no shut commands

>

> I have TwinTenGig Converter installed on Core Switch

>

>

> C4K_GLMMAN-3-X2PLUGGABLESEEPROMREADFAILED:

> Failed to read seeprom on port Te2/8. Reinsert X2 module or configure

> GigabitEthernet port group if TwinGigConverter is installed.

>

>

> Any suggestion help will be highly appreciated

>

>

> Regards

>

> Faizan Khurshid

>

>

> Blogs and organic groups at http://www.ccie.net

>

> _______________________________________________________________________

> Subscription information may be found at:

> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Mon Jan 23 2012 - 10:18:57 ART