Re: RIPNg over frame-relay multipoint interfaces! (Narbik WB)

Why does it surprise you ?
You are saying the same thing: if it is an IPv6 multicast send it via
DLCI 102.

-Carlos

Andy Hogard @ 20/08/2012 08:38 -0300 dixit:
> I was going through my Narbik set of WB's, and have realised that
>
>
> R1 -------------------------------------------------------- R2
> s2/0 s2/0
>
>
> R1,
> !
> interface Serial1/0
> no ip address
> encapsulation frame-relay
> ipv6 address FE80::1 link-local
> ipv6 address 2000:1:1:12::1/64
> ipv6 rip cisco12 enable
> no fair-queue
> serial restart-delay 0
> frame-relay map ipv6 FE80::2 102
> frame-relay map ipv6 2000:1:1:12::2 102 broadcast
> end
> !
>
> For R1 R2 RIPNg peering to work, in which frame-map should I configure the
> broadcast keyword... link-local or global. I have tried it on both turn by
> turn, it seems to work fine either ways eh!?
>

-- 
Carlos G Mendioroz  <tron_at_huapi.ba.ar>  LW7 EQI  Argentina
Blogs and organic groups at http://www.ccie.net