Re: AToM

Mohammad,

It has been awhile since I used GNS3, but I don't recall it ever
supporting POS interfaces.

--
Marko Milivojevic - CCIE #18427 (SP R&S)
Senior CCIE Instructor - IPexpert
On Wed, Dec 19, 2012 at 11:15 PM, Mohammad Khalil <eng_mssk_at_hotmail.com> wrote:
> Hi all
> I am using GNS3 to simulate some AToM scenarios
> My
> topology is R1 -- R2 -- R3 -- R4 -- R5
> Where R1 and R5 are my CE
> routers
> When i am using fastethernet all over the network everything is
> working normally and i established OSPF between the CEs without issues
> now ,
> i changed the connection between R1 and R2 to Serial and between R4 and R5 to
> POS
> Now the issue is when i configure the xconnect command on R2 , R1's s1/0
> becomes up down
> R1#sh int s1/0 | inc line
> Serial1/0 is up, line protocol
> is down
> I changed both encapsulations (PPP and HDLC) without solving
> The
> same is happening on POS interface
> R5#sh int pos1/0 | inc linePOS1/0 is up,
> line protocol is down
>
> Thanks in
> advance
>
> BR,
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net