Re: Frame-Relay Doubt

Hmm, it may just work with plain FR ?
I was curious and I set it up and it seems it does, with 2 different
addresses on the same network on the hub! (12.2(15)T7 just in case).

interface Serial1/0
  no ip address
  encapsulation frame-relay
  serial restart_delay 0
!
interface Serial1/0.1 point-to-point
  ip address 10.0.0.1 255.255.255.0
  frame-relay interface-dlci 101
!
interface Serial1/0.2 point-to-point
  ip address 10.0.0.3 255.255.255.0
  frame-relay interface-dlci 102

R2#sh frame map
Serial1/0.2 (up): point-to-point dlci, dlci 102(0x66,0x1860), broadcast
           status defined, active
Serial1/0.1 (up): point-to-point dlci, dlci 101(0x65,0x1850), broadcast
           status defined, active
R2#ping 10.0.0.2

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.0.0.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 8/20/36 ms
R2#ping 10.0.0.4

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.0.0.4, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 8/28/68 ms

This was done with two paralel DLCIs between two routers, BTW.
-Carlos

Imran Ali @ 05/02/2013 05:38 -0300 dixit:
> i dont think it is even possible to make two point to point interface
> with SAME subnet
>
> On Tue, Feb 5, 2013 at 11:21 AM, Saravanan Ponnaiah <
> saravanan.ponnaiah8_at_gmail.com> wrote:
>
>> Dear Expert,
>>
>> I have a doubt on the Frame Relay
>>
>> R1 ------- R2
>> |
>> |
>> |
>> |
>> R3
>>
>> *Note:All are need to be configure on the same subnet(10.10.10.0/24)*
>> *
>> *
>> R1 is the hub and R2 ,R3 are spoke.
>>
>> R2 & R3 is configured as Point-to-Point
>>
>> I also need a R1 to be configure as Point-to-Point , make it sure all to be
>> in same subnet. How it can be?
>>
>> With Regards
>>
>> P.Saravanan
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>

-- 
Carlos G Mendioroz  <tron_at_huapi.ba.ar>  LW7 EQI  Argentina
Blogs and organic groups at http://www.ccie.net