RE: Image verification

Use the verify /md5 to be completely sure.

By default the 4500's have confreg=2101, you need to change it to 2102.

Regards,

Antonio Soares, CCIE #18473 (R&S/SP)
amsoares_at_netcabo.pt
http://www.ccie18473.net

-----Original Message-----
From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
Imran Ali
Sent: segunda-feira, 4 de Novembro de 2013 06:32
To: Cisco certification
Subject: OT: Image verification

Hi all

i have uploaded an image and i have done verification .

core1#verify cat4500-entservicesk9-mz.122-54.SG1.bin
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
C
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
C
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
C
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
C
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
C
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
C
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
C
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
Verified cat4500-entservicesk9-mz.122-54.SG1.bin
SV-TS202-BB1#

1) what does this verification mean ? does it mean that checksum is
ok ?

or is it safe now to delete old image and reload so that it
boots with this image.

this is cat4506..

2) i have tried to set boot preference to new image ..but still it is
booting with old image ..
core1#show run | in boot
boot system flash bootflash:cat4500-entservicesk9-mz.122-54.SG1.bin

the issue is boot command is excepting any thing i type and not verifying
its syntax..

core1(config)#boot system flash abc
core1(config)#

what is the correct syntax .

Blogs and organic groups at http://www.ccie.net
Received on Mon Nov 04 2013 - 11:10:06 ART