From: GRIZZUTI Javier (jgrizzut@xxxxxxxxxxxxxx)
Date: Mon Nov 22 1999 - 19:59:54 GMT-3
Hey ALL
Is there a way to configure an ATM SVC enviroment with 2 ATM routers
connected back-to-back without a switch ?
I want to configure Classical IP between but I can't make them work.
This is the config I have
R1
interface ATM5/0
ip address 130.130.1.1 255.255.255.0
no ip directed-broadcast
no ip mroute-cache
atm arp-server self
atm uni-version 3.1
atm nsap-address AC.153366020000000000000000.000000000000.00
pvc sen 0/5 qsaal
!
pvc sen2 0/16 ilmi
R2
interface ATM8/0/0
ip address 130.130.1.2 255.255.255.0
no ip directed-broadcast
no ip route-cache distributed
atm nsap-address AC.245678040000000000000000.000000000000.00
atm uni-version 3.1
atm arp-server nsap AC.153366020000000000000000.000000000000.00
pvc sen 0/5 qsaal
!
pvc sen2 0/16 ilmi
These are some show commands
Router#sh atm map
Map list ATM5/0_ATM_ARP : DYNAMIC
arp maps to NSAP AC.153366020000000000000000.000000000000.00
Router#sh atm ilmi-status
Interface : ATM5/0 Interface Type : Private UNI (User-side)
ILMI VCC : (0, 16) ILMI Keepalive : Disabled
ILMI State: UpAndNormal
Peer IP Addr: 130.130.1.2 Peer IF Name: ATM8/0/0
Peer MaxVPIbits: 8 Peer MaxVCIbits: 10
I cannot ping the other side with SVC but I can do with PVC .
> ----------------------------------------------------------
> Ing. Javier Grizzuti- Systems Engineer
> Servicios de Ingeniería de Soporte
> SoftNet S.A. - Perú 327 1er Piso "A" (1067)
> Buenos Aires - ARGENTINA
> Phone: (54-1) 4343-4990 - Ext. 237
> Fax: (54-1) 4343-9132
> mailto:jgrizzut@softnet.com.ar
> http://www.softnet.com.ar
> ---------------------------------------------------------
>
>
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:55 GMT-3