From: Sam Munzani (sam@xxxxxxxxxxx)
Date: Fri Nov 03 2000 - 15:16:37 GMT-3
Now try running "IPX EIGRP" on that segment for both frame types. You can't,
can you? Then run Eigrp on one network and RIP on another. And make sure it
send out eigrp learned routs to rip network. It's a nice excercise and you
will learn a lot.
Sam
> That did it. Thanks.
>
> -----Original Message-----
> From: Arthur Davis [mailto:senzaart@usa.net]
> Sent: Friday, November 03, 2000 9:43 AM
> To: ccielab@groupstudy.com
> Subject: Re: [IPX - multiple frame encapsulations on one wire]
>
>
> Try a secondary network, i.e.
> ipx netw 700 encap arpa sec
>
>
>
>
>
>
> Ronnie Royston <RonnieR@globaldatasys.com> wrote:
> I am trying to configure multiple IPX frame types on one e-net segment.
It
> works fine with subinterfaces but I can only specify one network if I
simply
> configure multiple net #s / encaps types under the main int. only. In the
> latter case, the router takes the commands but only records the last
> net#/frame type in the running config ??? According to CCO, this is
> supposed to work without using subinterfaces. Any ideas? Thanks....
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:41 GMT-3