From: Feliz, Edgar (Edgar.Feliz@xxxxxxxx)
Date: Fri Nov 03 2000 - 15:21:32 GMT-3
Have you used the secondary command after your new encap type?
EF
-----Original Message-----
From: Ronnie Royston [mailto:RonnieR@globaldatasys.com]
Sent: Friday, November 03, 2000 12:23 PM
To: ccielab@groupstudy.com
Subject: IPX - multiple frame encapsulations on one wire
I am trying to configure multiple IPX frame types on one e-net segment. It
works fine with subinterfaces but I can only specify one network if I simply
configure multiple net #s / encaps types under the main int. only. In the
latter case, the router takes the commands but only records the last
net#/frame type in the running config ??? According to CCO, this is
supposed to work without using subinterfaces. Any ideas? Thanks....
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:41 GMT-3