From: Wu,Jiang (wujiang@xxxxxxxxx)
Date: Thu Nov 16 2000 - 07:58:05 GMT-3
Hi group,
I am tring gre tunnel and encountering a headache.... One of them does
not work well -- it can send packets but cannot receive any. The peer
router does send echo replies back. It seems that the incoming
interface's type which is dot1q trunking cause the problem. Though I
don't believe a layer 2 function has influence on layer 3... Can
anyone explain it?
Thanks,
Wu
Tunnel0 is up, line protocol is up
Hardware is Tunnel
MTU 1514 bytes, BW 9 Kbit, DLY 500000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation TUNNEL, loopback not set
Keepalive set (10 sec)
Tunnel source 138.3.40.5 (FastEthernet0/0.40), destination
138.3.40.4
Tunnel protocol/transport GRE/IP, key disabled, sequencing disabled
Checksumming of packets disabled, fast tunneling enabled
Last input 00:06:00, output 00:00:20, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/0, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
32 packets output, 2550 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:45 GMT-3