From: Bert Kellerman (bertke@xxxxxxxxxxx)
Date: Fri Nov 17 2000 - 08:28:39 GMT-3
Paste your configs....
> "Wu,Jiang" wrote:
>
> Hi group,
> I am tring gre tunnel and encountering a headache.... One of them does
> not work well -- it can send packets but cannot receive any. The peer
> router does send echo replies back. It seems that the incoming
> interface's type which is dot1q trunking cause the problem. Though I
> don't believe a layer 2 function has influence on layer 3... Can
> anyone explain it?
>
> Thanks,
> Wu
>
> Tunnel0 is up, line protocol is up
> Hardware is Tunnel
> MTU 1514 bytes, BW 9 Kbit, DLY 500000 usec,
> reliability 255/255, txload 1/255, rxload 1/255
> Encapsulation TUNNEL, loopback not set
> Keepalive set (10 sec)
> Tunnel source 138.3.40.5 (FastEthernet0/0.40), destination
> 138.3.40.4
> Tunnel protocol/transport GRE/IP, key disabled, sequencing disabled
> Checksumming of packets disabled, fast tunneling enabled
> Last input 00:06:00, output 00:00:20, output hang never
> Last clearing of "show interface" counters never
> Queueing strategy: fifo
> Output queue 0/0, 0 drops; input queue 0/75, 0 drops
> 5 minute input rate 0 bits/sec, 0 packets/sec
> 5 minute output rate 0 bits/sec, 0 packets/sec
> 0 packets input, 0 bytes, 0 no buffer
> Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
> 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
> 32 packets output, 2550 bytes, 0 underruns
> 0 output errors, 0 collisions, 0 interface resets
> 0 output buffer failures, 0 output buffers swapped out
-- Bert (RTP on 11/29)
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:45 GMT-3