From: YJC (stiff.yu@xxxxxxxxxxxxxxxxxx)
Date: Mon Feb 12 2001 - 00:17:00 GMT-3
but if you don't enable IRB,enable bridge under the interface will n't work,
you will found interface is ip routing not ip bridge.so I think it don't
correct
if you enable bridge under the interface.
----- Original Message -----
From: zhuqingliu <zql@liming.com>
To: <ccielab@groupstudy.com>
Sent: Friday, February 09, 2001 7:58 PM
Subject: Fw: Local area mobility w/o bridge group
> Sorry, The reason LAM not works properbly is my router configured with
irb.
> No mater if you configure bridge under interface or not, The LAM works.
>
> Regards,
> Perry
>
> ----- Original Message -----
> From: Perry Zhu <zql@liming.com>
> To: Patrick Bikar <pbikar@cisco.com>
> Cc: <ccielab@groupstudy.com>
> Sent: Friday, February 09, 2001 7:46 PM
> Subject: Re: Local area mobility w/o bridge group
>
>
> > In fact, I find that if you enable bridge under the interface, LAM will
not work properbly.
> > Am I right?
> >
> > regards,
> > Perry Zhu
> >
> >
> > ----- Original Message -----
> > From: Patrick Bikar <pbikar@cisco.com>
> > To: zhuqingliu <zql@liming.com>
> > Cc: <ccielab@groupstudy.com>
> > Sent: Friday, February 09, 2001 6:39 PM
> > Subject: Re: Local area mobility w/o bridge group
> >
> >
> > > Hi Perry,
> > >
> > > It is not required to configure bridge-group to have LAM working : the
doc
> > > CD is misleading for this.
> > >
> > > Check out :
> > > http://www.mentortech.com/learn/welcher/papers/mobileip.html
> > >
> > > Cheers,
> > > Patrick.
> > >
> > >
> > > At 14:14 09/02/2001 +0800, zhuqingliu wrote:
> > > >Hi,
> > > >
> > > > According to the cisco CD, Local area mobility configuration
need the
> > > > following step:
> > > > 1. enable proxy arp (default enabled)
> > > > 2. enable ip mobile arp
> > > > 3. redistirbute mobile host route in an routing protocol
> > > > 4. enable bridge under interface
> > > >!**********************************
> > > >bridge 1 protocol ieee
> > > >access-list 10 permit 192.100.100.55
> > > >interface ethernet 0
> > > > ip mobile arp access-group 10
> > > > bridge-group 1
> > > >router eigrp 100
> > > > redistribute mobile metric 10 2000 255 1 1500
> > > >!************************************
> > > >
> > > > But in my lab, w/o the "bridge-group 1" command LAM works
correctly.
> > > > Am I missing something?
> > > >
> > > >Best regards
> > > >Perry.Zhu
> > > >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:45 GMT-3