From: Gary Marsh (gfm@xxxxxxxxx)
Date: Mon Feb 19 2001 - 20:14:47 GMT-3
Scott,
You'll have to erase the file on partition 2 (the read/write partition, if
there is a file stored on it) before you issue the command no partition 2, I
think in config mode.
Then you need to change the config-register from 0x2102 to 0x2101 and reload
the router this will get you into boot mode from where you can copy a new
IOS to your single partition of 16Mb of flash. You will be prompted to erase
or not the existing IOS version in flash before you TFTP a new IOS into
flash.
Regards,
Gary
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of Scott
Schneidewind
Sent: Monday, February 19, 2001 9:19 PM
To: ccielab@groupstudy.com
Subject: Changing flash from "Read only"
Hello all.
I have some 2501 routers which each have two 8Mb sticks of flash ram in
them.
"Show Flash" lets me know that one is read/write and the other is read only.
How can I change the read only partition...so it can be erased and combined
with the other one.
-Scott
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:53 GMT-3