From: MOLINA, MARTIN J *Internet* (PBI) (mm1343@xxxxxxx)
Date: Sat Mar 09 2002 - 02:36:01 GMT-3
Small problem with my simulated Frame switch. I am using a 7505 with Legacy
Fast Serial Interface Processors as a Frame switch. My problem is the 7505
is not propagating pvc failures to the other end of the mock Frame circuit.
For example, using point to point sub-interfaces, if I perform a "shut" on
one end I fully expect to see the other end PVC status as "inactive". I see
it as active. Is anyone aware of any workarounds on the Frame Switch? I
can't use End to End Keepalive on the spokes. As luck would have it, the 2
spokes are not running IOS that supports FREEK. Thanks in advance.
Martin Molina
Senior Network Engineer
Pacific Bell Internet Services
CCNP CCDP
desk: 925 973-7774
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:58 GMT-3