From: Mingzhou Nie (mnie@yahoo.com)
Date: Sun Sep 15 2002 - 14:36:46 GMT-3
Oops, I guess I jumped into conclusion too early :) Then when don't you
open a Cisco TAC which no "dumb" answer can bother you.
Ming
--- Simon Bonham <simon.bonham@london.sns.slb.com> wrote:
> I was expecting a dumb answer like that.... If you read my mail
> properly,
> you will notice that I have the external DC power shelf.
>
> -----Original Message-----
> From: Mingzhou Nie [mailto:mnie@yahoo.com]
> Sent: 15 September 2002 17:56
> To: Simon Bonham; ccielab@groupstudy.com
> Subject: Re: OT: Cat 4006 with 48port F/E Inline Power unable to
> powerup
> 79x0 IP Phones :((((
>
>
> Simon,
>
> Just having the inline power module doesn't mean it has the inline
> power. To enable in-line power on the 4006, you must have the
> Catalyst
> 4000 Auxiliary DC Power Shelf and at least two power supplies
>
>
http://www.cisco.com/warp/public/788/AVVID/ip_pwr_detect.html#first-cat4k
>
> Ming
>
> --- Simon Bonham <simon.bonham@london.sns.slb.com> wrote:
> > Hi there,
> >
> > I am in a desperate situation at the moment. Currently busy with a
> > project
> > where we are installing 4 x Cat 4006 with 48 port FastEthernet
> Inline
> > Power
> > (WS-X4148-RJ45V) modules and a Supervisor II. The problem is that
> > when we
> > plug in the IP phones, they don't want to power up. I managed to
> get
> > one to
> > power up on for about two minutes before it died again. I can hear
> > the
> > relays clicking in the 48 port blade trying to apply power to the
> > phone, but
> > they just don't power up. I have swapped ever conceivable piece of
> > hardware
> > between the Cat 4006's. They all have the same symptoms. I have
> tried
> > about
> > 7 different 7940/7910 IP phones and none of them power up. I have
> > checked
> > and checked the configuration. Its straight forward, and the Inline
> > power is
> > enabled by default. I have tried three version of CATOS and that
> > doesn't
> > make any difference. I have checked the external DC power shelfs
> and
> > swapped
> > them between the Cat's. I have swapped the Supervisors, inline
> power
> > blades
> > and PEM modules to no avail :( I have pretty much run out of
> idea's.
> >
> > Can anyone help me?
> >
> >
> > Regards,
> >
> >
> > Simon.
> >
> > Simon Bonham - Senior Consultant
> > Schlumberger Network Infrastructure and Solutions
> > Email: simon.bonham@london.sns.slb.com - http://www.slb.com/nws
>
>
> __________________________________________________
> Do you Yahoo!?
> Yahoo! News - Today's headlines
> http://news.yahoo.com
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:43:52 GMT-3