From: Donny MATEO (donny.mateo@sg.ca-indosuez.com)
Date: Wed Sep 18 2002 - 23:15:07 GMT-3
try defining the neighbor on OSPF process at the Hub router. (R1 ? )
router ospf 1
neigh a.b.c.d
neigh e.f.g.h.
end
Donny
CTAlex405c@aol.co
m To: ccielab@groupstudy.com
Sent by: cc:
nobody@groupstudy Subject: Solie Skynet
.com
19-09-2002 08:57
Please respond to
CTAlex405c
Configuring the FR your not allowed to use 'ip ospf network' or I would have done a p2p and p2m. I
tried using 2 multipoint interfaces, one with frame map and one with frame interface-dlci. Not
getting adjacencies, . In the debug getting "OSPF: No full nbrs to build Net Lsa for interface
Serial0.2". Tried putting r1 at ospf priority 10 and the rest at 0. Can anyone give me a hint.
This message is for information purposes only and its content
should not be construed as an offer, or solicitation of an offer,
to buy or sell any banking or financial instruments or services
and no representation or warranty is given in respect of its
accuracy, completeness or fairness. The material is subject
to change without notice. You should take your own independent
tax, legal and other professional advice in respect of the content
of this message. This message may contain confidential or
legally privileged material and may not be copied, redistributed
or published (in whole or in part) without our prior written consent.
This email may have been intercepted, partially destroyed,
arrive late, incomplete or contain viruses and no liability is
accepted by any member of the Credit Agricole Indosuez group
as a result. If you are not the intended recipient of this message,
please immediately notify the sender and delete this message
from your computer.
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:43:56 GMT-3