From: CCIE Prep (cciemail@intellinet.ws)
Date: Sun Sep 22 2002 - 19:33:43 GMT-3
I have an MC3810 with the following show ver:
Cisco MC3810 (MPC860) processor (revision 10.03) with 27648K/5120K bytes of
memory.
Processor board ID 14761457
PPC860 PowerQUICC, partnum 0x0000, version C01(0x0031)
Channelized E1, Version 1.0.
Bridging software.
X.25 software, Version 3.0.0.
Primary Rate ISDN software, Version 1.1.
MC3810 SCB board (v11.A0)
1 Ethernet/IEEE 802.3 interface(s)
2 Serial(sync/async) network interface(s)
1 Channelized E1/PRI port(s)
256K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (AMD29F016)
Configuration register is 0x2102
As you can see it has "Channelized E1, Version 1.0" software. I have
installed a T1/E1 multiflex trunk module and it is not showing up in the
config. Is this an IOS incompatibility issue or could the hardware be
installed incorrectly. Has anyone out there put together one of these
before and run into this issue?
Thanks in advance.
__________
Nate Kleven
Senior Network Engineer, CCNP Voice Access, MCSE
Expanets
6020 So 190th ST
Kent, WA 98032
(206)219.6135
"Experienced at Networked Solutions"
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:44:00 GMT-3