From: Thomas Trygar (trygar@wans.net)
Date: Sun Sep 22 2002 - 20:56:25 GMT-3
Nate,
Cut and Paste a config.
You have to configure the "Controller T1":.
http://www.cisco.com/univercd/cc/td/doc/product/access/multicon/3810soft/swcfg/sportcfg.htm#xtocid3
Tom
CCIE Prep wrote:
> I have an MC3810 with the following show ver:
>
>
> Cisco MC3810 (MPC860) processor (revision 10.03) with 27648K/5120K bytes of
> memory.
> Processor board ID 14761457
> PPC860 PowerQUICC, partnum 0x0000, version C01(0x0031)
> Channelized E1, Version 1.0.
> Bridging software.
> X.25 software, Version 3.0.0.
> Primary Rate ISDN software, Version 1.1.
> MC3810 SCB board (v11.A0)
> 1 Ethernet/IEEE 802.3 interface(s)
> 2 Serial(sync/async) network interface(s)
> 1 Channelized E1/PRI port(s)
> 256K bytes of non-volatile configuration memory.
> 8192K bytes of processor board System flash (AMD29F016)
>
> Configuration register is 0x2102
>
> As you can see it has "Channelized E1, Version 1.0" software. I have
> installed a T1/E1 multiflex trunk module and it is not showing up in the
> config. Is this an IOS incompatibility issue or could the hardware be
> installed incorrectly. Has anyone out there put together one of these
> before and run into this issue?
>
> Thanks in advance.
> __________
>
> Nate Kleven
>
> Senior Network Engineer, CCNP Voice Access, MCSE
>
> Expanets
>
> 6020 So 190th ST
>
> Kent, WA 98032
>
> (206)219.6135
>
> "Experienced at Networked Solutions"
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:44:00 GMT-3