From: elping (elpingu@acedsl.com)
Date: Mon Sep 23 2002 - 01:01:47 GMT-3
I think i did mention that 100 meg was needed to complete this task...This is
what i have known and read...
but I was able to configure on a 3600 router a 10 meg only interface the
following..
so i think it is possible my friend....
r7#conf t
Enter configuration commands, one per line. End with CNTL/Z.
r7(config)#int e2/1.1
r7(config-subif)#en
r7(config-subif)#encapsulation ?
dot1Q IEEE 802.1Q Virtual LAN
sde IEEE 802.10 Virtual LAN - Secure Data Exchange
r7(config-subif)#encapsulation dot1Q ?
<1-4095> IEEE 802.1Q VLAN ID required, range 1 - 0xFFF.
r7(config-subif)#encapsulation dot1Q 1 ?
<cr>
r7(config-subif)#encapsulation dot1Q 1
Ahmed Al-Ghawas wrote:
> Regardless of the router model, you can only configure isl on an 100Mbps
> port. Configure it on an 10Mpbs port is not possible.
>
> HTH
>
> Ahmed
>
> ----- Original Message -----
> From: "Peng Zheng" <zpnist@yahoo.com>
> To: <ccielab@groupstudy.com>
> Sent: Saturday, September 21, 2002 9:07 PM
> Subject: Is it possible to config bridge under sub-interface for 2500 series
> router?
>
> > Hi,
> >
> > I tried, but it said sde or isl encapsulation is
> > required. But it's not a choices under the interface.
> >
> > Thank you for help.
> >
> > Best Wishes,
> > Peng Zheng
> >
> > __________________________________________________
> > Do you Yahoo!?
> > New DSL Internet Access from SBC & Yahoo!
> > http://sbc.yahoo.com
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:44:00 GMT-3