From: Gerry Hilton (gerry.hilton@rogers.com)
Date: Sat Mar 15 2003 - 19:58:26 GMT-3
Hi. Does anyone know if it is possible to have an ATM SVC on a
point-to-point subinterface? If so, could you please provide a valid
config? I am able to make it work on the main interface or a
multipoint subinterface. The following is the non-working config - the
ESI address has to be on the main interface as it's not allowed to be
configured on the point-to-point one. All of the addresses, etc.,
should be valid as they are used for working configs.
Thanks,
Gerry
router6-4500-1#sh ru int atm0
Building configuration...
Current configuration : 129 bytes
!
interface ATM0
no ip address
pvc 0/5 qsaal
!
pvc 0/16 ilmi
!
atm esi-address 111122223366.00
no atm ilmi-keepalive
end
router6-4500-1#sh ru int atm0.7
Building configuration...
Current configuration : 175 bytes
!
interface ATM0.7 point-to-point
ip address 50.0.0.6 255.255.255.0
!
svc testsub nsap 39.1122334455667700020114BB.111122223355.00
protocol ip 50.0.0.5 broadcast
!
end
router5-4500-2#sh ru int atm0
Building configuration...
Current configuration : 168 bytes
!
interface ATM0
no ip address
no ip route-cache
no ip mroute-cache
pvc 0/16 ilmi
!
pvc 0/5 qsaal
!
atm esi-address 111122223355.00
no atm ilmi-keepalive
end
router5-4500-2#sh ru int atm0.7
Building configuration...
Current configuration : 215 bytes
!
interface ATM0.7 point-to-point
ip address 50.0.0.5 255.255.255.0
no ip route-cache
no ip mroute-cache
!
svc subpoint nsap 39.1122334455667700020114BB.111122223366.00
protocol ip 50.0.0.6 broadcast
!
end
This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:40 GMT-3