From: Joseph Brunner (joe@affirmedsystems.com)
Date: Fri Sep 28 2007 - 00:32:32 ART
Here's some advice...
http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/ipv6
_c/sa_natpt.htm
get used to the doc cd. It's going to decide whether or not you buy a Cisco
exec 4 Hermes ties, or whether you buy a cisco exec 4 Hermes ties and get a
number for the effort.
Lab it up, lab it up, lab it up.
This is the coolest thing my old boss said about his CCIE persuit-
"the memory is in your fingers, not in your head"
-Joe
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
ISolveSystems
Sent: Thursday, September 27, 2007 10:05 PM
To: groupstudy
Subject: Simple IPv6 NAT config
R6 connects to R9 via Serial using IPv4 address. R6(104.69.69.6); R9(
104.69.69.9)
R6 Lo1 - 3333:6:6:6::6
R9 Lo1 - 3333:9:9:9::9
Task asks to configure IPv6 NAT over the serial link. Lo1 int should be
able to ping each other using IPv4 address from the shared subnet. Do not
use Overload.
Below is the config. Any idea why it doesn't work?
R6
ipv6 nat v6v4 source 3333:6:6:6::6 104.69.69.16
R9
ipv6 nat v6v4 source 3333:9:9:9::9 104.69.69.19
This archive was generated by hypermail 2.1.4 : Sat Oct 06 2007 - 12:01:16 ART