From: Luca Hall (lhall@setnine.com)
Date: Thu Jul 10 2008 - 13:50:50 ART
add:
priv config level 2 interface
----- Original Message -----
From: Joseph Brunner <joe@affirmedsystems.com>
To: 'Mark Stephanus Chandra' <mark.chandra@gmail.com>, 'Cisco certification' <ccielab@groupstudy.com>
Sent: Thu, 10 Jul 2008 12:41:19 -0400 (EDT)
Subject: RE: Local Authorication
sure add
privilege configure level 2 XXXXXXX
where XXXXXX = the commands you want to let the level 2 see in the running
conf.
i.e.
privilege configure level 2 crypto map
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Mark
Stephanus Chandra
Sent: Thursday, July 10, 2008 12:36 PM
To: 'Cisco certification'
Subject: Local Authorication
Hi All,
I have a question about Local Authorization.
I have a question that I have to set a user that only can do show run
command.
Can see the following configuration :
- hostname
- interfaces
- interface encapsulation
- ip access-list applied in interface
well, I have the solution to use p
privilege interface level 2 ip access-group
privilege exec level 2 show run
privilege interface level 2 encapsulation
privilege configure level 2 hostname
but when I try to login with privilege 2 and do the show run, I only get
this result :
Building configuration...
Current configuration : 69 bytes
!
!
hostname R6
!
boot-start-marker
boot-end-marker
!
!
!
!
!
!
end
I don't see any encapsulation interface, ip access-group.
Did I do something worng ?
Thanks in advance
Mark Stephanus Chandra
IT Consultant
This archive was generated by hypermail 2.1.4 : Mon Aug 04 2008 - 06:11:54 ART