RE: Port Channel not coming up

It is not a cabling issue.
When I shut both g1/5 and g4/15 down, the port to be first unshut will
stay up and the second will stay down.
Right now, g4/15 is up and g1/5 down.

________________________________

From: joshua atterbury [mailto:joshuaatterbury_at_gmail.com]
Sent: Tuesday, July 28, 2009 6:15 PM
To: Ananfack, Jeremie N
Cc: Joe Astorino; ccielab_at_groupstudy.com
Subject: Re: Port Channel not coming up

have you confirmed that it is not a cabling problem? Ie is you make
gi4/15 an access port and do the same for the other end does it come up?

On Wed, Jul 29, 2009 at 4:44 AM, Ananfack, Jeremie N
<jeremie_n_ananfack_at_fanniemae.com> wrote:

        The logical interface is already up.
        I was expecting a 2Gig interface and both g1/5 & g4/15 as
members of the
        channel.
        Still unable to bring up g4/15.

        rp01#sh int po3

        Port-channel3 is up, line protocol is up (connected)

         Hardware is EtherChannel, address is 00d0.c0d6.4fd2 (bia
        00d0.c0d6.4fd2)
         MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
            reliability 255/255, txload 1/255, rxload 1/255
         Encapsulation ARPA, loopback not set
         Keepalive set (10 sec)
         Full-duplex, 1000Mb/s
         input flow-control is off, output flow-control is off

         Members in this channel: Gi1/5

         ARP type: ARPA, ARP Timeout 04:00:00

        ________________________________

        From: Joe Astorino [mailto:jastorino_at_ipexpert.com]
        Sent: Tuesday, July 28, 2009 1:48 PM
        To: Ananfack, Jeremie N
        Cc: ccielab_at_groupstudy.com
        Subject: Re: Port Channel not coming up

        Allow the native VLAN on the trunks of the physical and logical
        interfaces.

        On Tue, Jul 28, 2009 at 12:01 PM, Ananfack, Jeremie N
        <jeremie_n_ananfack_at_fanniemae.com> wrote:

               Hello,

               Any suggestion as far as bringing this port channel up?
               The port channel interface is up but the other member of
the
        channel is
               down and doesn't show as a member of that channel.

               sw1
               interface GigabitEthernet1/5
               GigabitEthernet1/5 is up, line protocol is up (connected)
                description 1sharebc-sp01a
                switchport
                switchport trunk encapsulation dot1q
                switchport trunk native vlan 601
                switchport trunk allowed vlan none
                switchport mode trunk
                no ip address
                no snmp trap link-status
                channel-group 3 mode desirable non-silent
               !

               interface GigabitEthernet4/15
               GigabitEthernet4/15 is up, line protocol is down
(notconnect)
                description 1sharebc-sp01a
                switchport
                switchport trunk encapsulation dot1q
                switchport trunk native vlan 601
                switchport trunk allowed vlan none
                switchport mode trunk
                no ip address
                no snmp trap link-status
                channel-group 3 mode desirable non-silent
               !

               interface Port-channel3
               Port-channel3 is up, line protocol is up (connected)
                description 1sharebc-sp01a
               Members in this channel: Gi1/5
                switchport
                switchport trunk encapsulation dot1q
                switchport trunk native vlan 601
                switchport trunk allowed vlan none
                switchport mode trunk
                no ip address

==========================================================

               sw2
               set vlan 601 9/5-6
               clear trunk 9/5 1-4094
               set trunk 9/5 on dot1q
               clear trunk 9/6 1-4094
               set trunk 9/6 on dot1q
               set spantree portfast 9/5-8 disable
               set port channel 9/5-6 mode desirable non-silent

               Blogs and organic groups at http://www.ccie.net
Received on Tue Jul 28 2009 - 20:34:37 ART