Re: CE Dampening

Hi Tyson

Does this mean that dampening is enabled for all address families then?
Does enabling dampening on the vpnv4 address family only apply to
vpnv4 peerings or ipv4 peerings aswell?

On 2 September 2010 16:10, Tyson Scott <tscott_at_ipexpert.com> wrote:
> Dampening should be performed under the VPNv4 address family.
>
> Regards,
>
> Tyson Scott - CCIE #13513 R&S, Security, and SP
> Managing Partner / Sr. Instructor - IPexpert, Inc.
> Mailto: tscott_at_ipexpert.com
>
>
>
> -----Original Message-----
> From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
> Muzammil Malick
> Sent: Thursday, September 02, 2010 8:53 AM
> To: Cisco certification
> Subject: CE Dampening
>
> Hi Everyone
>
> I am trying to configure dampening on the peering to my CE under the
> address-family as follows
>
> router bgp 10
> address-family ipv4 unicast vrf RED
>
> But the command is not there, how would I dampen routes to specific peers?
>
>
> R1(config-router-af)#bgp ?
> redistribute-internal Allow redistribution of iBGP into IGPs (dangerous)
> router-id Router identifier configuration
> suppress-inactive Suppress routes that are not in the routing table
>
>
> Thanks
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Thu Sep 02 2010 - 16:17:30 ART