Experts,
I am running through a lab on OER. When I look at the sh oer master
active-probe output on my rack I see:
----
R6#sh oer master active-probes
OER Master Controller active-probes
Border = Border Router running this Probe
State = Un/Assigned to a Prefix
Prefix = Probe is assigned to this Prefix
Type = Probe Type
Target = Target Address
TPort = Target Port
How = Was the probe Learned or Configured
N - Not applicable
The following Probes exist:
State Prefix Type Target TPort How Codec
Unassigned echo 3.3.3.3 N Cfgd N
The following Probes are running:
Border State Prefix Type Target TPort
----
When I look at answer key it shows:
---
OER Master Controller active-probes
Border = Border Router running this Probe
= Probe is assigned to this Prefix
State = Un/Assigned to a Prefix
Prefix
Type = Probe Type
Target = Target Address
TPort = Target Port
llowing Probes exist:
tate Prefix
S
How = Was the probe Learned or Configured
N - Not applicable
The
f
o Type Target TPort How
Assigned 3.3.3.3/32 echo 3.3.3.3 N Cfgd
The following Probes are running:
Border State Prefix Type Target TPo
r1.1.1.6 ACTIVE 3.3.3.3/32 echo 3.3.3.3 N
----
Any ideas why my state is unassigned? Here is configuration from router
R6#sh run | b ^oer
oer master
policy-rules prfx
logging
!
border 1.1.1.6 key-chain OER
interface Serial0/0/0.62 external
interface FastEthernet0/1 external
interface FastEthernet0/0 internal
!
learn
delay
periodic-interval 3
monitor-period 1
no max range receive
mode route control
mode monitor active
!
active-probe echo 3.3.3.3
!
oer border
logging
local FastEthernet0/0
master 1.1.1.6 key-chain OER
!
ip prefix-list prfx seq 5 permit 3.3.3.3/32
Blogs and organic groups at http://www.ccie.net
Received on Sun Apr 22 2012 - 13:16:52 ART
This archive was generated by hypermail 2.2.0 : Tue May 01 2012 - 08:20:46 ART