Re: Cat3560 Eigrp Authentication

The key-string is under key 1 and it is eigrp200.
Show is in the email
Sent from my iPhone

> On Dec 1, 2013, at 7:38 AM, "Johnny Morris" <johnnymorris01_at_gmail.com>
wrote:
>
> You are using key chain LAB so you need to configure a key chain LAB with
key string. Go into key chain configuration mode.
>
>> On Nov 30, 2013 10:38 PM, "Daniel Barney" <daniel.barney.b_at_hotmail.com>
wrote:
>> Hello everyone
>> I am having trouble setting up EIGRP authentication, on a SVI ... Any
>> recommendations?
>>
>> SW1(config)#int vlan 1026
>> SW1(config-if)#ip authentication key-chain eigrp 200 LAB
>> SW1(config-if)#ip authentication mode eigrp 200 md5
>> SW1(config-if)#do sh run int vlan 1026
>> Building configuration...
>>
>> Current configuration : 104 bytes
>> !
>> interface Vlan1026
>> ip address 131.10.100.10 255.255.255.0
>> ip authentication mode eigrp 200 md5 ----/ Key-chain command is not set!
>> end
>>
>> SW1(config)#do sh ip eigrp 200 int det
>> EIGRP-IPv4:(200) interfaces for process 200
>>
>> Xmit Queue Mean Pacing Time Multicast
>> Pending
>> Interface Peers Un/Reliable SRTT Un/Reliable Flow Timer
Routes
>> Vl1026 1 0/0 6 0/1 50
0
>> Hello interval is 5 sec
>> Next xmit serial <none>
>> Un/reliable mcasts: 0/2 Un/reliable ucasts: 3/9
>> Mcast exceptions: 2 CR packets: 1 ACKs suppressed: 2
>> Retransmissions sent: 2 Out-of-sequence rcvd: 0
>> Topology-ids on interface - 0
>> Authentication mode is not set
>>
>> SW1(config-if)#do sh key chain
>> Key-chain LAB:
>> key 1 -- text "eigrp200"
>> accept lifetime (always valid) - (always valid) [valid now]
>> send lifetime (always valid) - (always valid) [valid now]
>>
>> Thank you all
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Sun Dec 01 2013 - 11:11:11 ART