Cat3560 Eigrp Authentication

Hello everyone
I am having trouble setting up EIGRP authentication, on a SVI ... Any
recommendations?

SW1(config)#int vlan 1026
SW1(config-if)#ip authentication key-chain eigrp 200 LAB
SW1(config-if)#ip authentication mode eigrp 200 md5
SW1(config-if)#do sh run int vlan 1026
Building configuration...

Current configuration : 104 bytes
!
interface Vlan1026
 ip address 131.10.100.10 255.255.255.0
 ip authentication mode eigrp 200 md5 ----/ Key-chain command is not set!
end

SW1(config)#do sh ip eigrp 200 int det
EIGRP-IPv4:(200) interfaces for process 200

                        Xmit Queue Mean Pacing Time Multicast
Pending
Interface Peers Un/Reliable SRTT Un/Reliable Flow Timer Routes
Vl1026 1 0/0 6 0/1 50 0
  Hello interval is 5 sec
  Next xmit serial <none>
  Un/reliable mcasts: 0/2 Un/reliable ucasts: 3/9
  Mcast exceptions: 2 CR packets: 1 ACKs suppressed: 2
  Retransmissions sent: 2 Out-of-sequence rcvd: 0
  Topology-ids on interface - 0
  Authentication mode is not set

SW1(config-if)#do sh key chain
Key-chain LAB:
    key 1 -- text "eigrp200"
        accept lifetime (always valid) - (always valid) [valid now]
        send lifetime (always valid) - (always valid) [valid now]

Thank you all

Blogs and organic groups at http://www.ccie.net
Received on Sat Nov 30 2013 - 21:37:45 ART