Re: MDS Zoneset Configuration Question

I believe they are pretty much the same. A show run zone should tell you for sure though.

Sent from handheld.

> On Dec 8, 2014, at 6:31 PM, "armylegionmedic_at_aol.com" <armylegionmedic_at_aol.com> wrote:
>
> Hello All,
>
>
> I was wondering something in regards to configuring zones and
> initiators on an MDS. Under the Zoneset name "Name" is there a different
> between using member (Zone name) verses just using zone name (zone name)? In
> the guide looks pretty much the same
>
>
>
>
>
>
>
> Command
>
> Purpose
>
>
> Step 1
> switch# config t
>
> Enters configuration mode.
>
>
> Step 2
>
> switch(config)#
> zoneset name Zoneset1 vsan 3
> switch(config-zoneset)#
>
> Configures a zone set
> called Zoneset1.
> Tip To activate a zone set, you must first create the zone
> and a zone set.
>
>
> Step 3
>
> switch(config-zoneset)# member Zone1
>
> Adds Zone1
> as a member of the specified zone set (Zoneset1).
> Tip If the specified zone
> name was not previously configured, this command will return the Zone not
> present error message.
>
>
> Step 4
>
>
> switch(config-zoneset)# zone name
> InlineZone1
>
>
> switch(config-zoneset-zone)#
>
>
>
> Adds a zone (InlineZone1) to
> the specified zone set (Zoneset1).
> Tip Execute this step only if you need to
> create a zone from a zone set prompt.
>
>
>
>
>
> Thanks,
>
>
> James
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Mon Dec 08 2014 - 23:44:12 ART