Re: MDS Zoneset Configuration Question

Ok, thank you Ryan

-----Original Message-----
From: Ryan West
<rwest_at_zyedge.com>
To: <armylegionmedic_at_aol.com> <armylegionmedic_at_aol.com>
Cc:
ccielab <ccielab_at_groupstudy.com>
Sent: Mon, Dec 8, 2014 3:44 pm
Subject: Re:
MDS Zoneset Configuration Question

I believe they are pretty much the same.
A show run zone should tell you for
sure though.

Sent from handheld.

> On
Dec 8, 2014, at 6:31 PM, "armylegionmedic_at_aol.com" <armylegionmedic_at_aol.com>
wrote:
>
> Hello All,
>
>
> I was wondering something in regards to
configuring zones and
> initiators on an MDS. Under the Zoneset name "Name" is
there a different
> between using member (Zone name) verses just using zone
name (zone name)? In
> the guide looks pretty much the same
>
>
>
>
>
>
>
> Command
>
> Purpose
>
>
> Step 1
> switch# config t
>
> Enters
configuration mode.
>
>
> Step 2
>
> switch(config)#
> zoneset name
Zoneset1 vsan 3
> switch(config-zoneset)#
>
> Configures a zone set
> called
Zoneset1.
> Tip To activate a zone set, you must first create the zone
>
and a zone set.
>
>
> Step 3
>
> switch(config-zoneset)# member Zone1
>
> Adds Zone1
> as a member of the specified zone set (Zoneset1).
> Tip If
the specified zone
> name was not previously configured, this command will
return the Zone not
> present error message.
>
>
> Step 4
>
>
>
switch(config-zoneset)# zone name
> InlineZone1
>
>
>
switch(config-zoneset-zone)#
>
>
>
> Adds a zone (InlineZone1) to
> the
specified zone set (Zoneset1).
> Tip Execute this step only if you need to
> create a zone from a zone set prompt.
>
>
>
>
>
> Thanks,
>
>
> James
>
>
> Blogs and organic groups at http://www.ccie.net
>
>
Received on Mon Dec 08 2014 - 18:45:25 ART