From: Kevin Baumgartner (kbaumgar@xxxxxxxxx)
Date: Mon Nov 06 2000 - 22:20:43 GMT-3
Yea I didn't mention that but that also is a cool feature you could do.
So from what I remember if you do something like this (using 5/55 that
was discovered using ilmi)
int atm3/0.5 mult
ip add 192.2.1.1 255.255.255.0
Kevin
At 01:49 PM 11/7/00 +1300, Justin Menga wrote:
>If you set up subinterface numbering that corresponds to the VPI values
>discovered (e.g. 0 and 5 in the example below), then the VCs discovered are
>automatically assigned to these subinterfaces (e.g. PVC 5/55 to subinterface
>int atm3/0.5).
>
>Regards,
>
>Justin Menga MCSE+I CCNP CCSE ASE
>WAN Specialist
>Computerland New Zealand
>PO Box 3631, Auckland
>DDI: (+64) 9 360 4864 Mobile: (+64) 25 349 599
>mailto: justin.menga@computerland.co.nz
>
>
>-----Original Message-----
>From: Kevin Baumgartner [mailto:kbaumgar@cisco.com]
>Sent: Saturday, 4 November 2000 1:07 p.m.
>To: ccielab@groupstudy.com
>Subject: Useful command to find ATM PVC's coming from LS1010 to router
>
>
> If you want to find the PVC's that are defined on the LS1010 for a
>router's ATM connection
>you can use the command "atm ilmi-pvc-discovery subinterface". This is very
>useful if you
>don't have access to the LS1010.
>
> So here is a short router configuration
>
>interface ATM3/0
> ip address 192.1.1.1 255.255.255.0
> atm pvc 1 0 16 ilmi <<<<<<<< Need to enable ilmi
> no atm ilmi-keepalive
> atm ilmi-pvc-discovery subinterface <<<<<<< Will auto detect the PVC's
>come to router from LS1010.
>
>
>sh atm vc
> VCD / Peak Avg/Min
>Burst
>Interface Name VPI VCI Type Encaps SC Kbps Kbps
>Cells Sts
>3/0 1 0 16 PVC ILMI UBR 155000
>UP
>3/0 3 0 100 PVC-D SNAP UBR 155000
>UP
>3/0 4 5 55 PVC-D SNAP UBR 155000
>UP
>
>So PVC's 0/100 and 5/55 have been detected from the LS1010.
>
> - Kevin
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:42 GMT-3